Hello gentelmans,
Is it possible to run S300 (hw. rev. 04.10 + 5.99 firmware) in CSV mode over free mapped PDOs as are 0x1600 + 0x0A00 over ETHERCAT please?
thanks
Regards Slav
Hi
I am searching servo drives for servo motors (AKM 11B, AKM 22C, AKM 53H) . I found, there are multiple options for the drives like AKD, AKD-BASIC, AKD2G, S300, S700. Can any one help differences between these series. I want to control…
I want to set motion with sinus-form velocity, so I need to use my custom acceleration profile table.
I used manual from here, but I can't understand what to do after I created csv-table with normalized current and position. 4_1_Table.txt…
How can I get current actual absolute position of multi-turn feedback from s300 servo amplifier?
If i use the PRD command i get current actual absolute position within only one turn.
Thanks!
Good day! I have an old 03.01 hardware revision s300 servo amplifier. Can you, please, send me last firmware file version 3.75-3.99 to upgrade my servostar? My local support can't help me. My email is [email protected]. Thank you!
Hello there!
I have a problem with my S300 (6A) servo amplifier, firmware – v5.86_ND0, hardware revision – 4.10.
It successfully worked with the motor on which SinCos Encoder W&S was installed (FBTYPE = 7), but after replacing my motor’s…
New Features
FailSafe over EtherCAT (FSoE) "Black Channel" Communication
AKD2G Drive Integration:
Backup/Restore
AKD2G with SMM options #2 (basic) and #3 (advanced)
Robotic Kinematic Transforms: T-Bot, H-Bot, and Gantry
IDE…
Good afternoon!
I have a circular motor that must rotate an object in the range from a certain degree to a certain degree with a certain step and a pause between steps.
For example, from -90 degrees to +90 degrees in increments of 5 degrees…
Home >
Knowledge Base >
Community >
Downloads >